Endoscope Pull Thru Cleaning Brush for 2.8–5mm Channels – Single Use

Pull Thru Cleaning Brush for endoscope channels (2.8mm–5mm). Effective single-pass cleaning of biopsy & accessory channels. Sterile & professional-grade.

Key Features Section

Single-pass channel cleaning
Fits 2.8mm–5mm ID instrument channels
Flexible design for smooth glide
Medical-grade bristles
Helps reduce infection risk

Additional Information

Always check the fit of the PULL THRU Cleaning Brush in the distal end prior to use, to ensure the correct brush has been selected.

The PULL THRU Cleaning Brush cleans best when submerged in a detergent bath (always wet the wipers prior to insertion in a channel) .

If you have accidentally used the wrong brush for your channel do not try and pull it out. Doing so may damage the scope and cause expensive repairs.

The PULL THRU Cleaning Brush products are designed to clean in a single pass. You should follow your in-house procedures when determining the number of passes to make through each channel. Always brush until the channel is clean.

	Check wipers against distal end first; if they feel too tight check the channel id from the endoscope manufacturer's manual.
	Insert the leader end first.
	When the leader exits the scope, pull through the endoscope until the PULL THRU Cleaning Brush has passed completely through.
	Check for soil on wipers 4 and 5. If there is soil, repeat steps 1-4 again.
	Push the leader end through; use short hand-strokes. The PULL THRU Cleaning Brush should pass easily through the channel.